Furnace length : 3m Heater temp : Upperside 550℃ Underside 350℃ Heater capacity : Upperside 54kW Underside 10kW SCR control Complete with Hot wind generator and VOC recovery subsystem
Roll support type
Conveyor arrier type
(Both type use is possible)
7、Infeed and Outfeed
Air pinch method Drive inverter draw control method
8、Winder
Center wind method
Core : 3inch MAX winding diameter : φ400mm Tension : 15kg/width MAX
9、Laminator
10、Environment
Complete with Air conditioner
Indoor non-explosion proof area
For small labs spec
This apparatus can change coating thickness easily.
The basic spec is very cheap.
Basic spec
Sheet width
250mm MAX
Line speed
5m/min MAX
Coating thickness Roll coater Die coater
2~30μm (WET) 2~100μm (WET)
Heater temp
500℃ MAX
Guide roll
300mm
Tension
3kg/width MAX
Environment
Clean, explosion proof selection is possible
Apparatus spec
An winder
Structure Winding diameter Control Chuck
Cantilever φ200mm MAX Open loop control Air shaft
Feed apparatus
Structure Drive Control
Roll nip method Variable motor Draw control
Roll coater
Method Coating width Coating thickness Drive Control
3roll structures multi coater Gravure Direct reverse (other 4kind) 500mm 2~50μm (WET) Variable motor (Servo etc) Draw control
Die coater
Method Coating width Coating thickness Viscosity Control
Slit die coater 400mm 2~100μm (WET) 1~10000cps Draw control
Heater
Method Effective width Furnace length Heater capacity Ceramic Hot wind
IR and Hot wind combined use 220mm 1000mm 600W SL ceramic Option
Winder
Structure Winding diameter Control Chuck
Cantilever φ200 MAX Dancer control Air shaft
Operator control panel
Structure Insaide Panel side
The machine side installation (Dustproof structure) Sequencer, Inverter, SCR Touch panel, Temperature controller and others Emergency stop
Option
Motors kind Selection is possible (Reproducibility changes) Hot wind combined use (Possible to raise dry speed) Gravure roll (1kind is included in basic apparatus) transfer roll (1kind is included in basic apparatus)